Dear Admin,

I am running Ubuntu linux 14.04 LTS, x86_64-Ubuntu-linux-gnu/64bit with 128bit integers. i recently installed MonetDB5 default branch from the mercurial repository.

I tried to rebuild and enable geom module but to no avail, it shows no error, after compilation it shows that the module is enabled,However when i run the mserver the monetDB/GIS module is not loaded as expected. I am stuck and i don't seem to know how to proceed forward in order to run my spatial queries

Are there any setting i need to do explicitly to load this module?

the command i used: ./configure --prefix=/home/joweria/MonetDB-Nov2016-SP4 --enable-geom=yes --enable-pyintegration=yes --with-geos=yes

and then after compilation under the LDFLAGS-enabled componets

geom is one of the enabled componet but when i run the mserver5 the module is not loaded as expected.

I rebuild monetDB again and for first time i run the mserver5 commans and the GIS module was successfully loaded ie (MonetDB/SQL/GIS module is loaded) but when i closed the session (\q) and ran the same command again the module was not loaded. i tried exporting paths to no avail. what could be the problem? please i need your kind help.

Thank you

Regards,

Joweria nakibuuka